Hammer Mills Parts

We stock direct-from-the-factory hammer mill parts that have been tested and inspected to meet the highest standards for quality and dependability in the industry. With our stocking program, your parts can be stored virtually anywhere in the world, ready for immediate delivery.

CONTACT US FOR PARTS

Hammer Mill Screens

We carry a complete selection of hammer mill screen types and sizes for sizing and milling powders, grains, resins and other dry materials, including:

  • Rasping screens
  • Round hole perforated screens
  • Square hole perforated
  • Striated screens
  • Straight-slot screens
  • Diagonal-slot screens

Screen sizes vary from 0.30mm (0.12”) to 38mm (1.5”). Customized screens are available. Your Fitzpatrick sales engineer can help you make the right selection.

Hammer Mill Motors

Hammer mill drive motors are available for virtually any worldwide electrical standard. We can provide motors for variable or single-speed operation, as well as motors with special service and temperature ratings, including explosion-proof, washdown, and TEFC.

Hammer Mill Controls

When you need machine-mounted hammer mill controls, remotely mounted controls, or mobile enclosures, The Fitzpatrick Company has you covered. 

Rotor/Blade Assemblies

Selecting the proper blade is important for achieving desired particle sizes. Fitzpatrick carries a wide selection of OEM replacement hammer mill blades and rotor/blade assemblies. 

We can provide knife-edged and blunt-edged blades, as well as reversible blades with one edge type on either side for even greater versatility. Fixed and removable tip blade assemblies are also available.

  • Replacement Blades for Fitzmill D12 Models
  • Replacement Blades for Fitzmill D6 Models
  • Replacement Blades for Fitzmill F Models

Feed Throats

Looking for replacement feed throats for FitzMill hammer mills? Contact us today. FitzMill feed throats provide exacting control over feed angle, assuring consistent, predictable results. We offer a wide range of standard and custom throats. We can even provide feed throats designed for heat transfer or introduction of inert gases.

Variable Feed Screw System (VFS)

Overfeeding or underfeeding can cause unpredictable results. The FitzMill variable feed screw (VFS) assures precisely controlled feed rate to deliver more consistent results and minimize waste. The variable feed screw system is also preferred when grinding is required.

Replacement Shafts and Flywheels

  • Replacement Shaft/Parts for Fitzmill D-Model
  • Replacement Shaft/Parts for Fitzmill DASO6
  • Replacement Shaft/Parts for Fitzmill FASO20/12/8
  • Replacement Shaft/Parts for Fitzmill Model DKASO12
  • Replacement Shaft/Parts for Fitzmill Model DS6

Looking for replacement feed throats for FitzMill hammer mills? Contact us today. FitzMill feed throats provide exacting control over feed angle, assuring consistent, predictable results. We offer a wide range of standard and custom throats. We can even provide feed throats designed for heat transfer or introduction of inert gases.

Request a Quote More Products

User Benefits